How does a DC power supply work?

February 14, 2025common problems 6570

A DC power supply converts alternating current (AC) electricity to DC electricity either by a linear method or by a switching method. Switching power supplies are more efficient, lighter in weight and smaller in form factor. Linear power supplies can achieve lower noise, but this is no longer an advantage with modern switching power supplies.

Previous. How do I use a DC power supply?NEXT STORY. What is a benchtop DC power supply?

How does a spectrum analyzer work?
February 14, 2025 877
A signal that looks very complex in the time domain behaves quite differently in the frequency domain. Time domain measurements show an impure sine wave. Without frequency domain measurements, it is still impossible to know the source and frequency of the second harmonic. Spectral analysis can show the spectral components individually, thus revealing the source of the interference. The information provided in the time domain (e.g., the signal pulse on...
View Full Version
What are the types of network analyzers?
February 14, 2025 790
Network analyzers are key instruments used to measure the performance of RF and microwave devices, and their types can be categorized according to different criteria as follows: The selection of network analyzers needs to be based on the measurement needs (e.g., frequency range, accuracy, portability) and application scenarios (R&D...
View Full Version
How do I measure voltage?
February 14, 2025 771
How do I measure voltage? If you use a multimeter, anyone can measure it easily ■ Summary Since voltage is not visible to the naked eye, it is not possible to confirm "how much voltage is flowing through a circuit at a glance". However, the circuits of electronic devices have a set voltage for normal operation, and if the voltage is too high, it may lead to product malfunction or personal injury. In addition, ...
View Full Version
How to use an arbitrary waveform generator?
February 14, 2025 752
Using an arbitrary waveform generator, test engineers can verify the design of a circuit in just a few steps: (1) activate the output control; (2) select the waveform to be generated; (3) connect the output to the device under test; and (4) verify the performance of the device under test using an oscilloscope. The following is an example of the design of the output control circuit.
View Full Version

Hello!sign in

How does a DC power supply work?

Recommended

How does a spectrum analyzer work?

What are the types of network analyzers?

How do I measure voltage?

How to use an arbitrary waveform generator?

Learn about us

client service

Product Center

Follow the public number

Contact Us