Goodwell Electronics has newly launched APS-7200& 7300 AC Power Supplies. The maximum rated output of APS-7200 is 2000VA, 310Vrms, 16.8Arms; APS-7300 is 3000VA, 310Vrms, 25.2Arms, and the output frequency is 45.00~500.0Hz, and the output voltage is 0~600Vrms and the output frequency is 45~999.9Hz. The output voltage 0~600Vrms and output frequency 45~999.9Hz can be expanded directly from the user's end through the optional mode, without the need to return to the factory for modification. It is suitable for testing and development of AC-DC power supply devices, consumer electronics, automotive electronics and electronic components.<\/p>\n
APS-7200 & 7300 have 9 measurement items (Vrms, Irms, F, Ipk, W, VA, PF, Ipk hold, CF), and provide similar AC Power Meter interface, which is suitable for LED industry or standby power consumption measurement. In ARB mode, APS-7200 & 7300 provide SINE waveform, Triangle waveform, Staircase waveform, Clipped Sinewave, Crest factor waveform, Surge waveform and Fourier series. The APS-7200 & 7300 provide SINE waveform, Triangle waveform, Staircase waveform, Clipped Sinewave, Crest factor waveform, Surge waveform, and Fourier waveform, which can satisfy the industry's need to test abnormal waveforms in analog input power supply. 10 sets of Preset settings are available for the user to store 10 sets of settings; the Power ON Output setting allows the output of Sequence, Simulate, and Program to be performed automatically after power on.<\/p>\n
In order to meet the common test conditions of consumer electronics products with variable input power supply, APS-7200 & 7300 provide five ways to cope with special or abnormal changes in voltage, frequency, phase, 10 Simulate groups to simulate the behavior of power interruption, voltage increase or voltage decrease, and 10 Sequence groups to allow users to customize the parameters and generate sine wave through steps editing; 10 groups of Program for editing AC waveform output, and can be customized for different DUT measurement items above\/below the limit; Ramp Control allows the user to set the speed of change of the output voltage rise and fall; Surge\/Dip Control can simulate the DUT's input power supply at a specific time to generate a Surge or Dip voltage iterated on the output voltage waveform. APS-7200 & 7300 not only provide OCP\/ OPP\/ OTP protection, but when the voltage\/current phase difference of 180 degrees (reverse current) is detected at the output of the back panel, the front panel reading will be displayed in red font to remind the user, which is suitable for inverter feedback grid test, and the current measurement result of the feedback grid will be displayed.<\/p>\n
APS-7200 & 7300 backplane Ethernet Port can be used for remote program control, Sync Output Socket provides 10V output voltage for external synchronization, Signal Output connector provides program execution result monitoring, APS-7200 & 7300 also provides The APS-7200 & 7300 also provide Trigger In\/Out and Output on\/Off remote control functions on the J1 connector on the rear panel.<\/p>","protected":false},"excerpt":{"rendered":"