What is Keysight Trueform Waveform Generation Technology?

common problems 3900

Trueform waveform generation is a technology unique to the Keysight 33600A and 33500B series Trueform waveform generators. Keysight Trueform technology represents another leap forward in waveform generation technology, giving you the best of both worlds: it's comparable in cost to DDS technology, but delivers predictable, low-noise waveforms that don't skip a single wave point, just like PPC technology.

Previous. NEXT STORY.

Recommended

  • What is a current probe?

    528

    Many people use digital multimeters to easily measure current, voltage, resistance, etc. However, there is a drawback to using a digital multimeter to measure current, namely: the circuit must be disconnected and the digital multimeter must be connected in series with the circuit under test in order to make the measurement. In this case, a current probe can be used instead of a digital multimeter to make measurements. Since the electrical connection of the circuit is no longer required, the current probe is more time-consuming...

    View Full Version
  • How do I calibrate my spectrum analyzer?

    376

    You can use the Keysight U9361 RCal Receiver Calibrator to perform an accurate and reliable calibration of your spectrum analyzer/signal analyzer by following these steps: Learn more about how to calibrate a spectrum analyzer. , and

    View Full Version
  • What are the types of network analyzers?

    446

    Network analyzers are key instruments used to measure the performance of RF and microwave devices, and their types can be categorized according to different criteria as follows: The selection of network analyzers needs to be based on the measurement needs (e.g., frequency range, accuracy, portability) and application scenarios (R&D...

    View Full Version
  • What is a function/waveform generator?

    454

    A function generator is an electronic test device that generates a variety of standard waveforms for a device under test (DUT), such as sine, square, ramp, or sawtooth waveforms. In circuit design and circuit boards, testing often requires the use of controlled signals to simulate routine operations. Testing physical systems and sensors often requires stable and reliable signals that are as low as a few microvolts and may be as high as...

    View Full Version

Hello!sign in

Click to cancel reply
    Expand More

    Product consultation and purchase:18218718851

    I already understand