Comprehensive test and measurement service provider-Shenzhen Weike Electronic Technology Co.
产品概述: Fluke Networks LinkIQ™ 工业以太网线缆/网络测试仪
LinkIQ™ 可测量长度达到 1000 ft (305 m) 的线缆，并提供与开路点、短路点和未端接线缆等故障点的距离。
随附的 MS-IE 远程适配器可发现 RJ45、M12X、M12D 和 M8D 端接线缆上的接线错误和分拆线对。
LinkIQ™ 支持 EtherNet/IP、PROFINET、EtherCAT 和其他工业以太网，并可证明 10BASE-T 至 10GBASE-T（10 Mb/s 至 10 Gb/s）的布线带宽是否符合要求，还提供最近交换机的诊断信息（包括标称数据速率、交换机名称、端口号和 VLAN 信息）以及高达 8 级 (90W) 的 PoE 测试和负载测试。
包括 LinkIQ™ 主机、Remote ID #1、RJ45-RJ45 跳线 (M-F)、RJ45-RJ45 跳线 (M-F)、快速参考指南、交流充电器、RJ45/11 通用连接器、RJ45/M12X 跳线、RJ45/M12D 跳线、RJ45/M8D 跳线、RJ45/11 模块化适配器、带 Remote ID 夹扣的挂带、手提包（便携包）。
产品规格: Fluke Networks LinkIQ™ 工业以太网线缆/网络测试仪
| functionality | instructions |
| User Interface (UI) Supported Languages | English (SW v1.0) |
| weights | 1 lbs 6 oz (624g) |
| batteries | Type: Lithium battery, 3.6 V, 6400 mAh Endurance: 8 hours (standard) Charging time: 4.5 hours Charging temperature range: 0 °C to +40 °C |
| power adapter | Input: 100 - 240 VAC ±10%, 50/60Hz Output: 15 VDC, 2 A maximum Category II |
| Host Interface | USB Type C |
| monitor | 800 x 480 capacitive multi-touch color screen |
| sizes | 8.5 in x 4.5 in |
| operating temperature | 0 °C to 45 °C |
| storage temperature | -10 °C to +60 °C |
| Operating relative humidity | 0 % - 90 % (0°C - 35°C) 0 % - 70 % (35°C - 45°C) |
| Working altitude | 4000 m ( (3200 m with AC power adapter) |
| vibratory | Random, 2 g, 5 Hz-500 Hz |
| fall | 1 meter drop, 6 sides |
Active Network Diagnostics
| functionality | instructions |
| diagnostic protocol | Link Layer Discovery Protocol (LLDP) Cisco Discovery Protocol (CDP) Fast Link Pulse (FLP) |
| Diagnostic information for recent equipment (where available through diagnostic protocols) |
Switch Name port number VLAN Name nominal data rate Nominal Duplex |
| Power over Ethernet compatibility | IEEE 802.3af/at/bt Hardware negotiation with the characteristic resistor Software negotiation with LLDP/CDP |
| Power over Ethernet Diagnostic Information | Nominal Power Rating (0 to 8) Nominal available power wire bonding Single-feature and dual-feature diagnostic information |
| Power over Ethernet Measurements | Load Voltage (V) Load Power (W) |
| Port Indicator Lights Blinking | Indicator light of the connected port is blinking |
Cable Test Specifications
| functionality | instructions |
| test port | Shielded 8-pin modular jack for 8-pin modular (RJ45) plug. |
| Debugging of automated tests | 10GBASE-T, 5GBASE-T, 2.5GBASE-T, 1000BASE-T, 100BASE-TX, 10BASE-T, wiring diagrams only. Test speed: 6 seconds, for lengths < 70 md |
| Cable Type | Balanced Twisted Pair Cabling unshielded twisted pair Shielded Twisted Pair 2 and/or 4 pairs |
| Wiring diagram test only | Record wiring diagrams Length of each pair Diagnostic split-line pairs User selectable T568A or T568B User selectable crossover settings (straight, half, full) Test speed: 1 sec. for lengths . |
| Length (maximum) | 305 m (1000 ft) |
| Nominal Velocity of Propagation (NVP) | User settable |
| tone generator | Generates digital audio compatible with Fluke Networks IntelliTone probes. Generates analog audio compatible with generic analog probes. |
| Remote ID Locator | Use Remote ID terminals to identify up to 7 unique ports or office outlets |
型号: Fluke Networks LinkIQ™ 工业以太网线缆/网络测试仪
LIQ-100-IE
LIQ-100-IE 工业以太网线缆/网络测试仪
Attached:
- LinkIQ™ Host
- Remote ID #1
- RJ45-RJ45 跳线 (M-F)
- RJ45-RJ45 跳线 (M-F)
- Quick Reference Guide
- AC charger
- RJ45/11 Universal Connector
- RJ45/M12X Patch Cord
- RJ45/M12D Patch Cord
- RJ45/M8D 跳线
- RJ45/11 模块化适配器
- 带 Remote ID 夹扣的挂带
- 手提包（便携包）
Recommended
